Infinity Verandas
Glass Rooms for Hot Tubs · North Yorkshire

Bespoke Glass Rooms for Hot Tubs for Selby Homes and Gardens

We design every spa room around the tub you already own, not a stock size. Lid arc, deck substrate, and circulation space all measured on the survey, the drawing follows the survey rather than the other way round. Most people asking about a hot tub glass room here want hot tub glass room rather than a full building project. The survey covers substrate, falls, drainage outfall and access width before anything is priced. Aftercare is handled in-house, no manufacturer call centre in the middle. YO8 postcodes are standard coverage, along with the North Yorkshire network around them.

Free site survey 0114 312 3771
Glass Rooms for Hot Tubs designed for a Selby garden near Selby Abbey

Selby customers most often want

a glass spa room off a rear extension in Selby

a fully enclosed glass room over an existing Selby hot tub

a glass-walled spa house set back from the house across a paved patio

Trust and guarantees

  • up to 10 year warranty across frame and glass
  • ridge and roof vents sized to the specific tub steam output
  • double-glazed units seated in chemical-safe gaskets
  • stainless fittings on every fixing inside the spa zone

Our process from survey to handover

  1. Step 1
    electrical coordination with tub circuit
  2. Step 2
    manufacture in 5-7 weeks
  3. Step 3
    install typically 2-3 days on site
  4. Step 4
    commissioning of vents, lighting, and any sensors
  5. Step 5
    survey with tub in place, clear circulation, lid arc, existing drainage
  6. Step 6
    spec, ventilation, glazing grade, and drainage detail

Nearby areas we cover

Our install team runs Selby bookings alongside neighbouring North Yorkshire runs, most of these sit on the same weekly schedule.

Glass Rooms in York
roughly 14 miles from Selby
See page →
Glass Rooms in Doncaster
roughly 20 miles from Selby
See page →
Glass Rooms in Leeds
roughly 22 miles from Selby
See page →
Glass Rooms in Pontefract
roughly 12 miles from Selby
See page →

What goes into the frame

  • thermally broken aluminium frame with vented ridge for steam release
  • toughened double-glazed units with chemical-resistant seals
  • sliding glass wall for ventilation on hot days
  • stainless steel fixings throughout the spa zone

Frequently asked questions

Can you route power and lighting?

Yes, we coordinate with your electrician on power runs and fit dimmable LED and dusk sensors inside the frame.

How long does install take?

Two to three days on site for a typical Selby spa room. Wet trades for base work, if needed, add a week to the overall programme.

In YO8 specifically: what roof options work best on Selby rear elevations?

On Georgian townhouses near the Abbey we tend to specify a lower pitch with a larger gutter; on 1970s semis in Barlby and Brayton there is usually more head height to work with. Glass, polycarbonate and solid-deck all get considered against how much light the room behind loses.

Can you match the frame colour to existing Selby windows?

Yes. Frames are powder-coated to any RAL, and on the survey we take a reference from the existing windows and rainwater goods rather than guessing from a photo.

Covering Pontefract too: will a hot tub glass room suit an exposed plot on the edge of Selby?

Yes, with the right section sizes. Exposed North Yorkshire plots get heavier posts, closer fixing centres and, where it helps, side screens on the prevailing wind side.

Related pages

Next step

A hot tub glass room in Selby is only as good as its fixings, its drainage, and its finish, those three details are where we spend our time.

Request a survey 0114 312 3771

We cover Selby and out to York on the same weekly run

Get your free quote